1.0m³ Front Lift Bin

The Front Lift Bin’s unique features allow the user to control many aspects of the waste materials properties. The odour can be controlled with the UV stable plastic lids fitted. The unit’s lid not only controls odour, but serves as a pest deterrent as well. Any sensitive waste may be managed with the lockable lug and chain fitted to all Flow Force manufactured units, preventing unauthorised access. The lid is fitted with a lid stay, allowing the lid to be left open. The lid stay design enables the operator to select one of three predetermined positions, slightly open, half open or fully open. The lid also has the capacity to fold back completely and rest on the rear of the bin.

Another user friendly feature is the wheel system employed. This allows for the 1.0m³ Front Lift Bin to be easily positioned, by a single person, or moved to accommodate the needs of the user. Each Bin is fitted with two lockable free castoring steel wheels and two fixed steel wheels bolted to underneath the pockets. This enables the replacement or removal of wheels as required. The 1.0m³ Front Lift Bin has been structurally engineered to hold 1 cubic meter of solids. It, therefore, has the potential to weigh 1 metric ton. This capacity should be taken into account when moving a full unit around, as it may have the kinetic energy to overpower the person/person’s manually positioning the unit.

All front Lift Bins are emptied and cleaned via the purpose built truck that is fitted with forward facing tynes that locate into the side pockets fitted at a standard height to all bins. The bin is raised over the top of the truck, emptying into the truck’s onboard compactor unit. The empty bin is then repositioned for filling again.

All Units are fitted with a 50mm bung that can be screwed closed, thus making the unit water tight, or removed to allow excess water to be removed.

REMEMBER IT IS AN OFFENCE TO ALLOW CONTAMINATED WATER TO ENTER THE WATERWAYS.

Front Lift Bins can be manufactured and supplied without Lids and Wheels, or fitted with non marking wheels for internal use in factory’s and offices.

Standard material for manufacture is 3mm mild steel construction.
The standard finish applied to the product is enamel paint.
Structural design and material selection of these units are in accordance with AS2359.1.
Welded fabrication of the product is in accordance with AS 1554.1 SP.

Special Note:
Units can be manufactured in 304 Stainless Steel with Stainless Steel lids for use in hospitals and human waste facilities.