Fork Tyne Extensions Class 4

Fork extensions are designed to temporarily extend the standard forks fitted to the fork truck. When in use the extensions should be loaded evenly and used to stabilize the load. Under no circumstances should the slippers be used to carry the entire load and should not exceed more than one third of the parent fork length.

The extensions should slide over the standard forks completely until the retention pins can be positively locked into place. The inside pocket dimensions of the fork slippers are: Class 2 – 140 x 64mm, Class 3 – 180 x 69mm, and Class 4 – 220 x 82mm.

Please specify parent fork tyne dimensions, i.e. length, width and height, when ordering slippers.

The standard finish applied to the product is ‘safety yellow’ enamel paint.

Structural design of and material selection for this product is in accordance with AS2359.1 and AS2359.15.

Welding fabrication of the product is in accordance with AS1554.1 SP.

PART NUMBER	MASS Kg	PRODUCT DIMENSIONS LxWxH	MIN. PARENT FORK LENGTH	CENTRE OF GRAVITY	S.W.L. CAPACITY
FF-FE4-1525	156	1525 x 250 x 98 mm	1200mm	Hor. 709 mm	12000 Kg @ 762 mm
FF-FE4-1605	164	1605 x 250 x 98 mm	1200mm	Hor. 749 mm	11500 Kg @ 802 mm
FF-FE4-1676	171	1676 x 250 x 98 mm	1200mm	Hor. 784 mm	10500 Kg @ 838 mm
FF-FE4-1830	187	1830 x 250 x 98 mm	1200mm	Hor. 860 mm	9000 Kg @ 915 mm
FF-FE4-2130	218	2130 x 250 x 98 mm	1800mm	Hor. 1009 mm	8500 Kg @ 1065 mm
FF-FE4-2440	250	2440 x 250 x 98 mm	1800 mm	Hor. 1163 mm	7500 Kg @ 1220 mm
FF-FE4-3000	307	3000 x 250 x 98 mm	1800mm	Hor. 1442 mm	6400 Kg @ 1500 mm