Fork Tyne Extensions Class 2

Fork extensions are designed to temporarily extend the standard forks fitted to the fork truck. When in use the extensions should be loaded evenly and used to stabilize the load. Under no circumstances should the slippers be used to carry the entire load and should not exceed more than one third of the parent fork length.

The extensions should slide over the standard forks completely until the retention pins can be positively locked into place. The inside pocket dimensions of the fork slippers are: Class 2 – 140 x 64mm, Class 3 – 180 x 69mm, and Class 4 – 220 x 82mm.

Please specify parent fork tyne dimensions, i.e. length, width and height, when ordering slippers.

The standard finish applied to the product is ‘safety yellow’ enamel paint.

Structural design of and material selection for this product is in accordance with AS2359.1 and AS2359.15.

Welding fabrication of the product is in accordance with AS1554.1 SP.

PART NUMBER	MASS Kg	PRODUCT DIMENSIONS LxWxH	MIN. PARENT FORK LENGTH	CENTRE OF GRAVITY	S.W.L. CAPACITY
FF-FE2-1525	63	1525 x 152 x 76 mm	1200 mm	Hor. 684 mm	4900 Kg @ 762 mm
FF-FE2-1605	66	1605 x 152 x 76 mm	1200 mm	Hor. 724 mm	4700 Kg @ 802 mm
FF-FE2-1676	68	1676 x 152 x 76 mm	1200 mm	Hor. 759 mm	4500 Kg @ 838 mm
FF-FE2-1830	75	1830 x 152 x 76 mm	1200 mm	Hor. 834 mm	4100 Kg @ 915 mm
FF-FE2-2130	86	2130 x 152 x 76 mm	1800 mm	Hor. 983 mm	3500 Kg @ 1065 mm
FF-FE2-2440	99	2440 x 152 x 76 mm	1800 mm	Hor. 1136 mm	3100 Kg @ 1220 mm